Application

      Please start with a clean surface. Make sure the temperature is above 60.

     Your graphic will be in 3 parts; the backing, graphic, and the transfer tape.

     Make sure the graphic is well attached to the transfer tape.
     You can lay it on a table and rub it with a credit card.

     For small graphics you can install them dry.
     Just peel off the backing, place on the surface and run into place.
     Then carefully remove the transfer tape.

     For large graphics you can install them wet or dry
     For wet, add a few drops of dish soap into a bottle of water or use Rapid Tac
     Mist the area of the graphic, remove the backing and apply to the surface.

     Rub out from center. A credit card works good for this.
     Make sure you get the air bubbles out. Then gently remove the backing.
     We now sell Rapid Tac 4oz for $6